Features - Irritrol TOTAL CONTROL 6 Guía De Instalación Y Programación

FEATURES

Thank you for purchasing a Total Control irrigation system controller.
Listed below are some important features you should be aware of
before you begin programming. Details on how to implement these
features are described on the following pages.
• Four fully independent programs that can run concurrently
• Watering day scheduling by Weekdays, Odd/Even days (with
selective day removal) or Day Interval from 1 to 30 days.
• 365-day calendar with automatic compensation for leap year
• Sixteen total start times to use in any program
• Start time stacking overlap protection within each program
• Station watering time from 0 minutes to 10 hours in 1-minute
increments
• Program information erase feature selectable by program
• Non-volatile program memory retains programming information
for up to 30 years without power
• Battery backup maintains time and date during a power failure for
over 2000 continuous hours on a single 9-volt alkaline battery.
• Water budgeting from 0 to 200% in 10% increments
• Rain delay programmable to 7 days
• Self-diagnostic electronic circuit breaker that identifies and over-
rides faulty stations
• Master valve/pump start operation selectable per program
• Complete manual operations available by station and program
• Sensor switch connection for operation with any normally-closed
rain switch device
• Slide switch control provided for rain switch sensor override
• Modular design for ease of programming, installation and service
To take full advantage of all Total Control features, please review the
User's Guide completely before programming or installing your new
controller.
i
Features