Master Valve/Pump Start On/Off; Setting Program Start Times - Irritrol TOTAL CONTROL 6 Guía De Instalación Y Programación

5. Repeat steps 3 and 4 to set a run time for each station you wish to
assign to the selected program.
6. Repeat steps 2 through 5 for each program as necessary.

MASTER VALVE/PUMP START ON/OFF

The Total Control enables automatic operation of the Master
Valve/Pump Start output circuit to be controlled independently for
each watering program. For example, if a program is used for drip
irrigation and the system pump is not required, the Master
Valve/Pump Start output circuit can be shut off whenever that
program begins operation.
The factory setting is
select the operation of this feature for each program as necessary.
1. Turn the function dial to the
2. Select Program
3. Press the
NEXT
displayed.
4. Press the
OFF
valve/pump start output for the selected program.
5. Repeat steps 2 through 4 for each program as necessary.
SETTING PROGRAM START TIME(S)
This procedure is used to set the watering cycle start time(s) for each
program. A maximum of 16 start times can be allocated to the four
programs in any manner. Each start time will initiate a sequential
watering cycle of all stations with an assigned run time in the program.
Note: When 16 start times have been allocated, the display will show
NONE REMAINING
To set program cycle start time(s):
1. Turn the function dial to the
2. Select Program
3. Use the + and/or – buttons to display the start time.
Note: To remove a start time, adjust the time to display
(located between 11:59 p.m. and 12:00 a.m.).
4. Press the
NEXT
program.
5. Repeat steps 2 through 4 for each program as necessary.
Programming the Controller
12
for each program. Use the steps below to
ON
Station Times
, , or with the
A B C D
button repeatedly until
or button to display the operation of the master
ON
when attempting to assign additional start times.
Program Start Times
, , or with the
A B C D
button to assign another start time to the
position.
switch.
Program
is
MASTER VALVE
position.
switch.
Program
OFF