Adjustments; Clinch Adjustment; Depth Of Drive Adjustment - Bostitch DSW-3519 Manual De Operación Y De Mantenimiento

• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not operate tool if all covers are not installed.
• Do not operate the tool when not placed on a work surface.
• Do not use this stapler for fastening electrical cables. It is not designed for
electric cable installation and may damage the insulation of electric cables
thereby causing electric shock or fire hazards.

ADJUSTMENTS

Clinch Adjustment

To obtain maximum efficiency from the staple closure, it is important that the staple be
clinched properly. Proper clinching for any thickness board may be obtained by adjusting
the clincher setting with staples of proper leg length. Use the proper length staples for the
thickness of work to be stapled, otherwise unnecessary pressure is exerted and staple
crowns and legs will be distorted, or the clinch will be too loose.
Disconnect the battery before adjusting the clinch tightness of
the tool.
1. To loosen the fastener clinch turn the clinch dial to the right.
2. To tighten the fastener clinch, turn the clinch dial to the left.

Depth Of Drive Adjustment

Remove the battery before adjusting the depth of drive.
1. Push to release the locking feature, and turn the depth adjustment knob clockwise
to decrease the depth of drive.
2. Push to release the locking feature, and turn the depth adjustment knob counter
clockwise to increase the depth of drive.
TIGHT
MEDIUM
LOOSE
DEEP
MEDIUM
SHALLOW
CLINCH
DIAL
DEPTH
ADJUSTMENT
KNOB
15-ENG