Electrical Installation - SICK GRSE18V Instrucciones De Operación

6

Electrical installation

8021182.1ABM / 2020-12-21 | SICK
Subject to change without notice
NOTE
Swap the sender and receiver arrangement at every second photoelectric through-
beam sensor and ensure that there is sufficient distance between the through-beam
photoelectric sensors.
Sender (GS)
Receiver (GE)
Sender (GS)
Figure 2: Arrangement of several through-beam photoelectric sensors
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (following tables):
Q / Q = switching outputs
TI / Test = test input (see table
n. c. = not connected
U : 10... 30 V DC, see „Technical specifications", page 13
B
Table 1: DC, GRS
GRS18(S)V D11xxx
1 + (L+)
2 n. c.
3 - (M)
4 Test
1 = BN
2 = WH
3 = BU
4 = BK
0.14 mm
2
AWG26
ELECTRICAL INSTALLATION
> 0 V) once all electrical connec‐
V
4)
D13x2/4x D13x1/3x
+ (L+) + (L+)
n. c. n. c.
- (M) - (M)
Test n. c.
4 3 4
1 = BN
2 = WH
1 2 1
3 = BU
4 = BK
0.14 mm
2
AWG26
Receiver (GE)
Sender (GS)
Receiver (GE)
= 0 V). The following informa‐
V
D24xxx D23x2/4x D23x1/3x
+ (L+) + (L+) + (L+)
n. c. n. c. n. c.
- (M) - (M) - (M)
Q Test n. c.
3 4 3 4
2 1 2
1
6
3
2
7