Hardware Selection Part Two: Outer Cane Clamps
Instructions: Select the correct outer cane clamps. Then, continue with "Hardware Attachment".
1. Measure the diameter of the wheelchair canes. Diameter = "X".
2. Select the correct outer cane clamps.
X =
1 in. (2.5 cm)
X =
¾ in. (2 cm)
Note: The ¾ in. (2 cm)
outer cane clamp has
a "dimple" next to the
opening for the cane
clamp screw.
X ≠
¾ in. (2.0 cm)
1 in. (2.5 cm)
Note: An image may not be the actual size of the component.
ROHO AGILITY CARBON Contour Back Support Operation Manual
(x2)
dimple
(x2)
If the diameter (X) of the wheelchair back canes does not equal ¾ in. (2.0 cm) or 1 in. (2.5 cm), ask the
product provider about compatibility.
6
X
X
Top view
Top view