Product Removal; Hardware Removal - Permobil ROHO AGILITY CARBON Manual Del Usuario

Product Removal

Warning: DO NOT remove the product while the individual is seated in the wheelchair.
For back canes WITHOUT push handles:
1. Loosen, but do not remove, the cane
clamp screws on each side.

Hardware Removal

Warning: In order to correctly and securely install the product, you MUST use the correct hardware. See "Hardware Selection".
Note: To replace hardware, follow the removal instructions and then follow the "Hardware Attachment" instructions.
Outer Cane Clamp Removal
1. For both sides, remove the cane clamp screw and
the outer cane clamp.
2. Continue with the "Hardware Attachment" section
in this manual.
Disc Removal
Note: Disc "A" is shown.
1. For both sides, remove the outer and inner cane
clamps:
a. Remove the cane clamp screw and the outer cane
clamp.
b. Remove the angle adjustment screw and the inner
cane clamp.
2. For both sides, remove the discs:
a. Turn the inner cane clamps upside down to drop out
the discs.
b. Pry the discs from both sides of the back shell. Use
the T-Handle Wrench or a small, flathead screwdriver
(or other tool).
Tip: Place the T-Handle Wrench in the center of the
disc, and move the handle in a circular motion.
3. Continue with the "Hardware Attachment" section in this
manual.
ROHO AGILITY CARBON Contour Back Support Operation Manual
2. Lift to slide the product off the
wheelchair canes.
Inner Cane Clamp
For back canes WITH push handles:
1. On both sides, remove the cane clamp screw and the outer cane clamp.
2. Remove the product from the wheelchair.
Back Shell
11
Note: The 1 in. (2.5 cm) outer cane clamp
is shown.