Hardware Selection - Permobil ROHO AGILITY CARBON Manual Del Usuario

Hardware Selection Part One: Discs / Screws
Warnings:
- If the wrong hardware is used, the product will NOT fit correctly on the wheelchair. Follow these instructions to select the correct hardware. Consult with a
clinician or the equipment provider for assistance.
- If the product was provided already installed on the wheelchair, it is not necessary to select new hardware. However, if you are going to remove the product and
install it on a different wheelchair, make sure to follow all Hardware Selection and Product Installation and Adjustment instructions before using the product.
Instructions: Select the correct discs and screws. Then, continue with "Hardware Selection Part Two: Outer Cane Clamps".
STEP ONE: Find the Back Shell Width.
Refer to the label on the back shell and
the tables below.
Back Shell Width
14
15
16
17
18
14
15
16
17
18
14
15
16
17
18
ROHO AGILITY CARBON Contour Back Support Operation Manual
STEP TWO: Find the correct Width Range:
Measure the distance between the outsides of
the wheelchair canes, as shown. Refer to the
tables below.
Width Range
cm in.
34.9 - 35.9 133/4 - 141/8
37.5 - 38.4 143/4 - 151/8
40 - 41 153/4 - 161/8
42.5 - 43.5 163/4 - 171/8
45.1 - 46 173/4 - 181/8
cm in.
35.9 - 36.8 141/8 - 141/2
38.4 - 39.4 151/8 - 151/2
41 - 41.9 161/8 - 161/2
43.5 - 44.5 171/8 - 171/2
46 - 47 181/8 - 181/2
cm in.
36.8 - 37.5 141/2 - 143/4
39.4 - 40 151/2 - 153/4
41.9 - 42.5 161/2 - 163/4
44.5 - 45.1 171/2 - 173/4
47 - 47.6 181/2 - 183/4
STEP THREE: Select Option 1, 2, or 3 (based on the Back Shell
Width and the Width Range).
Note: Each Option includes two (2) discs and one (1) screw for each
side of the back shell (total of 4 discs and 2 screws). Set aside any
remaining parts.
L
L
= Left Side
A
A
20mm
L
= Left Side
A
A
25mm
L
= Left Side
B
B
30mm
5
R
Option 1
R
= Right Side
A A A
A A A
Option 2
R
= Right Side
B B A
B
B A
Option 3
R
= Right Side
B B B
B B B
20mm
25mm
30mm