Data Table - Wilo Medana CH1-L Instrucciones De Instalación Y Funcionamiento

en
Example:
1
L
6
02
1
E
A
10
T
3.2

Data table

Maximum utilisation pressure
Maximum operating pressure
Maximum suction pressure
Notice: the suction pressure (P input) + the pressure at
zero delivery rate (P zero delivery rate) must always be
lower than the maximum authorised operating pressure
(P max). P input + P zero delivery rate ≤ P max. Refer to
the pump rating plate for the maximum operating pres-
sure: P max.
Temperature range
Fluid temperature
Ambient temperature
Electrical data
Motor protection rating
Insulation class
Frequency
Voltage
Motor efficiency
Other characteristics
Humidity
Altitude
Motor power (kW)
22
Product information
Medana CH1-L.602-1/E/A/10T
Series level (1 = entry level, 3 = standard level, 5 = premium level)
L = Long shaft
E = Electronic control
3
Delivery rate in m /h
Number of impellers
1 = Pump housing in 1.4308 stainless steel + hydraulics in 1.4307 stainless steel
2 = Pump housing in 1.4409 stainless steel + hydraulics in 1.4404 stainless steel
E = EPDM seal
V = FKM seal
A = Frequency 50 Hz / single-phase / 230 V
B = Frequency 60 Hz / single-phase / 220 V
C = Frequency 60 Hz / single-phase / 230 V
D = Frequency 50 Hz / three-phase / 400 V
E = Frequency 50 Hz / three-phase / 230 – 400 V
F = Frequency 60 Hz / three-phase / 220 – 380 V
G = Frequency 60 Hz / three-phase / 265 – 460 V
I = Frequency 60 Hz / three-phase / 460 V
Maximum pressure of the pump in bar
T = Screwed connections
P = Victaulic connections
N = Connections with captive nut
See pump type key on rating plate and paragraph 3.1
6 bar
-20 °C to +120 °C with EPDM seals
-20 °C to +90 °C with VITON seals
(only on version L)
-15 °C to +50 °C
See plate
See plate
See plate
See plate
See plate
< 90 % without condensation
≤ 1000 m (> 1000 m on request)
Noise level
Frequency (Hz) Phase dB(A) at 1 m, BEP tolerance
0 – 3 dB(A)
WILO SE 02/2021