SICK SureSense HSE18L Manual De Operación página 54

62 拆卸和废弃处理
63 保养
8017857.YMH6 | SICK
Subject to change without notice
LED 指示灯 / 故障界面 /
LED indicator/fault pattern
黄色 LED 亮起，光路中无物
体 /
Yellow LED lights up, no ob‐
ject in the path of the beam
必须根据当地特定的法律法规废弃处理传感器。如果其中含有可回收材料（尤其是
贵金属），则必须在废弃处理时回收利用。
SICK 传感器无需保养。
我们建议，定期：
• 清洁镜头检测面
• 检查螺栓连接和插头连接
不得对设备进行任何改装。
如有更改,不另行通知。所给出的产品特性和技术参数并非质保声明。
原因 /
Cause
某个单向光栅的光束照射到
另一个（相邻）单向光栅的
接收器上 /
The beam of light of a pho‐
toelectric through-beam
sensor hits the receiver of
another (neighboring) pho‐
toelectric through-beam
sensor
62
拆卸和废弃处理
措施 /
Measures
Check the operating condi‐
tions: Fully align the beam
of light (light spot) with the
receiver. / Clean the optical
surfaces . / Readjust the
sensitivity (potentiometer) /
If the potentiometer is set to
the max. sensing range:
Reduce the distance betwe‐
en the sender and the re‐
ceiver, and check against
graphic H. / Check sensing
range and adjust if neces‐
sary; see graphic H. / With
health output: Check the
power supply, check all
electrical connections (ca‐
bles and plug connections).
每隔一个单向光栅即交换发
射器和接收器的顺序或在各
个单向光栅之间保留足够间
距。 /
Swap the sender and recei‐
ver arrangement at every
second photoelect‐
ric through-beam sensor
and ensure that there is suf‐
ficient distance between the
through-beam photoelectric
sensors
53