Setting New Probe Cap Parameter; Protection Cover - OHAUS STARTER 400D Manual De Instrucciones

STARTER 400D Portable DO Meter
3.7

Setting New Probe Cap Parameter

When replace a new probe cap, user must input the parameter of this new cap into the meter. Or
the measurement value will be incorrect.
Probe Body
Press button-
setting screen. Input the parameter of the new cap. Then do calibration before any measurement.
Find Quality Products Online at:
Protection
Probe
Cap
O-ring
, button- and button-
GlobalTestSupply
www.
Cover
together to enter the new probe cap parameter
.com
EN-9
sales@GlobalTestSupply.com