diversey Taski Swingo 455B Traducción De Las Instrucciones Originales De Usщ página 11

Empty and clean the recovery tank and fresh
water tank
Notice:
Drain water or cleaning solution must be disposed
of in compliance with the national regulations.
Notice:
When draining the recovery tank, the regulations of
the detergent supplier regarding personal protec-
tive equipment of the cleaning solution manufactur-
er must be observed.
Proceed as follows:
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
Cleaning the recovery tank and fresh water tank
• Open the tank lid.
• Remove the dirt sieve (yellow), emp-
ty it and thoroughly rinse it under run-
ning water.
• Remove the tank from the machine.
• Rinse the recovery tank and the fresh
water tank thoroughly with clean wa-
ter.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
Caution:
Clogged suction filters may impair the suction per-
formance.
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
• Reinsert the tank into the machine.
• Reassemble the dirt sieve (yellow) and the suction filter.
Cleaning the fresh water tank filter
Caution:
Clean the fresh water tank filter after the end of op-
eration.
Clogged filters can inhibit the supply of detergents and
thus lead to surface damage.
10
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
Notice:
The filter is lower than the drain hole of the tank. A
rest amount of cleaning solution will run out only
when the filter is removed.
• Put the filter back and twist it closed.
Removing and cleaning the brush
Notice:
Clean the brush whenever cleaning work is com-
pleted.
• The machine must be switched off.
• To lift the tool, push the foot pedal
downwards until it engages.
• Rotate the tool counterclockwise
away from the tool connection using
your foot.
• Clean the tool under running water.
Cleaning the machine
Caution:
Never clean the machine with a high-pressure
cleaner or water jet.
Water ingress in the machine may cause considerable
damage to the mechanical or electrical parts.
• Wipe the machine with a moist cloth.
Storing / parking the machine (not in opera-
tion)
Caution:
The machine must be switched off (main switch)
and the battery disconnection plug must be discon-
nected.
Notice:
Store the machine with a lifted suction nozzle, lifted
brush and open tank lid.
Thus, the tank can dry, and the generation of mold and
unpleasant odors is prevented.
Caution:
Never store the machine with uncharged batteries.
Otherwise, the batteries will be damaged beyond repair.