Safety And Warning Instructions; Warning Caution; Symbols - Bosch rexroth 3 842 998 350 Manual De Instrucciones

8/78 About this documentation
Bosch Rexroth AG, MPS: HEAP, 3 842 555 612/2019-01
1.3.1

Safety and warning instructions

This documentation contains safety instructions in chapter 2.6 "Product-specific
safety instructions" and chapter 3 "General information on damage to property and
product damage". Warnings can be found before a sequence of actions or before
instructions whenever there is a risk of injury or damage to property. Be sure to
observe all safety precautions.
Safety instructions are structured as follows:
Type and source of danger!
Consequences of non-compliance
Steps to prevent danger
„
...
„
• Warning sign: Points out the danger
• Signal word: Indicates the severity of the danger
• Type and source of danger: Indicates the type and source of the danger
• Consequences: Describes the consequences of non-compliance
• Prevention: States how the danger can be avoided
Table 2: Risk classes according to ANSI Z535.6-2006
Warning sign, signal word
DANGER
WARNING
CAUTION
NOTICE
1.3.2

Symbols

The following symbols indicate important information that is not safety-relevant but
increases the comprehensibility of the documentation.
Table 3: Meaning of the symbols
Symbol Meaning
If this information is not observed, the product cannot be used and/or
operated as designed.
Single, independent action
„
1. Numbered steps:
the numbers indicate that the steps must be performed in order.
2.
3.
SIGNAL WORD
Meaning
Indicates a hazardous situation that will result in serious
injury or death if not avoided.
Indicates a hazardous situation that may result in severe
injury or death if not avoided.
Indicates a hazardous situation that may result in minor to
moderate injury if not avoided.
Property damage: The product or the surrounding area
could be damaged.