Publicidad
Idiomas disponibles
Idiomas disponibles
SIMPLIFIED INSTRUCTIONS FOR K800-1400-2200 FCE-FCM WITH K-CRX
1° Connecting the motor and limit switch (done in the factory)
2° Connecting the accessories
3° Installing and adjusting the limit plate cams
Place the cams on the rack.
Tighten the two screws to lock them. How to finely
adjust cam intervention is explained below.
K FCE
ITA
ESP ENG FRA GRE DEU RUS ARA THAI BUL FAR TUR
CAPACITOR
BROWN
BLUE
M
BLACK
MOTOR
K FCE
BLUE
A
A
A
NO
NO
NC
NC
C
C
ANTENNA – Use an RG58 co-axial cable
ELECTRICAL SUPPLY
quick connector
Press. Insert the wire.
Release to lock it.
K FCM
IMPORTANT
The motor is set to open towards the right.
If opening is to the left, the LSO and LSC wires on terminal block J2 and the V
and W wires on terminal block J7 must be reversed.
A* A
Jumper
COM-EDGE
A
A
A
Release the motor (turn the key counter clockwise until the limit is
reached without forcing) and move the gate by hand
Check when the cams are activated.
Note: The cams must press the electric microswitches before the mobile
part touches the mechanical stops.
HIN
CHI
K FCE
K FCM
NC
A* A
S
C
S
A*A => A+A- Observe the polarity
of the photocells' electrical supply
POL HUN CEK KOR
Publicidad
