Connecting The Accessories - RIB K400 Manual De Instrucciones

SIMPLIFIED INSTRUCTIONS FOR K400 WITH K 24V-CRX
1° Connecting the accessories
ANTENNA
433 MHz
ANTENNA BRAIDING
COMMON
PHOTOCELLS
PEDESTRIAN
SINGLE COMMAND
A+TEST / A-
SAFETY DEVICE
24Vdc 0,4A ±15%
AUTO-TEST OR
ENERGY SAVING
24Vdc 0,4A ±15%
(LOW POWER) WITH
BATTERY OPERATION
2° Installing and adjusting the limit switch cams
Position the cams at the ends of the rack rail.
Tighten the two screws to secure them in place.
Open the shutter door of the K400.
Insert the key and turn in a clockwise direction.
Pull the lever to unlock the operating system.
Check the cam intervention point by opening and closing the gate.
N.B.: The cams should press the electric micro-switches before the moving part
touches the mechanical stops (K400 FCE). The DL7 and DL8 LEDs switch off
when the cams are detected by the proximity sensor (K400 FCM).
Position the gate halfway and re-secure the operating system.
ITA ESP ENG FRA GRE DEU RUS ARA THAI BUL FAR TUR
STOP
EDGE
CLOSE
OPEN
TIMER
24Vdc 20W
24Vdc 10W
L.S. OPEN
AND CLOSE
ENCODER
M
MANUAL
RELEASE
SAFETY
POWER SUPPLY
230Vac 50Hz
24Vac
0
10Vac
BACKUP BATTERIES
FOR BATTERY CHARGER
BOARD (OPTIONAL)
HIN CHI POL HUN CEK KOR
FUSE
T 1,6A
TRANSFORMER
K400 FCE
K400 FCM