Intended Use; Warranty; Transport And Storage; Identifying The Product - HURNER WeldControl 2.0 1200 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
must have participated in a dedicated training. The operating/
owning organization engages to check at reasonable intervals
if the system is operated by the welders as intended and under
proper guidelines of occupational safety.
• The system must be operated only when in proper state of repair
and for one of the intended uses. Before welding, the welder is
required to make sure that the state of the system is in order.
During transport, the facing tool and the heating element
have to be placed into the provided carrying rack at all
times.
Important
The dust cap for the data tranfer interface port has to cover
the port during operation, in order to keep humidity and
contaminations away.
Important
2.5

Intended Use

The welding system is intended exclusively for joining plastic pipes
and fittings according to the butt-welding process with heating ele-
ment. See Section 3 for an overview of the welding process enabled
by this system.
The notion of intended use also includes:
• Compliance with the instructions in the User's Manual
• Observation of all service and maintenance intervals
All uses other than those mentioned above are not allowed
and will cancel any and all liability or warranty by the manu-
facturer. Unintended use may cause considerable hazards and
Important
material damage.
2.6

Warranty

Warranty claims may be raised only if the conditions for warranty given
in the General Terms and Conditions of Sale and Delivery obtain.
2.7

Transport and Storage

When the product is transported or stored, the hydraulic tubing should
not be detached or squeezed. For transporting the pipe facing tool
and the heating element, use the provided carrying rack at all times
and never connect them to, or disconnect them from, the hy-
draulic unit unless the hydraulic unit is switched off.
2.8

Identifying the Product

Every product is identified by a name plate. It shows the model ("Typ"),
the serial number ("Maschinennr."), and the manufacturer. The first
two digits of the serial number represent the year of manufacture.
3

Understanding the Machine

This butt-welding machine for plastics can be used both as an on-site
and as a workshop installation, for jointing operations pipe-to-pipe,
but also for processing tees and elbows (see also the first paragraphs of
Sect. 4.3 and 4.4 for more detailed information on this). The machine
enables welding according to two modes, the Manual Mode and the
Data Logging/Report Generation mode, or Weld Control Mode for
short.
Version July 2020 HÜRNER WeldControl 2.0 1200 User's Manual
Stumpfschweißsystem
Typ WeldControl 2.0 1200
Maschinennr. 14557001
Hürner Schweisstechnik
Nieder-Ohmener Str. 26
D - 35325 Mücke D - 35325 Mücke
Tel. +49 6401 9127 0
7
EN