Emptying Waste Container - Kärcher KM 130/300 R LPG Manual

Upgrade kit water spray system (option)
This upgrade kit is factory-installed and
cannot be installed retroactively.
The water spray system upgrade kit con-
sists of a water tank and the spray nozzles
on the side brushes.
 If a lot of dust is generated during
sweeping, the water spraying system
can be used.
 The switching is done via the irrigation
switch for the side brush.
Sweeping dry floors
 Switch on the blower.
 Set the programme switch to sweep
with sweeping brush when cleaning
surfaces.
 Set the programme switch to sweep
with sweeping brush and side brush
when cleaning edges.
Sweeping damp or wet floors
 Switch off the blower.
 Set the programme switch to sweep
with sweeping brush when cleaning
surfaces.
 Set the programme switch to sweep
with sweeping brush and side brush
when cleaning edges.

Emptying waste container

Danger
Risk of injury! When emptying the waste
container, care should be taken to ensure
that no persons or animals are within its
swivelling range.
Danger
Danger of crushing. Never reach into the
rod assembly for the drainage mechanism.
Stay away from the area under the raised
container.
Danger
Danger of tipping. Place the machine on an
even surface during emptying.
 Set programme selection switch to
"Transport drive". .
 Raise waste container.
28
 Slowly drive towards the collection con-
tainer.
 Lock parking brake.
 Open the container door: Press the left
side of the switch and empty the waste
container.
 Close the container door: Press the
right side of the switch (approximately 2
seconds), until the unit is tilted to the
end position.
 Release parking brake.
 Drive away the collection container
slowly.
 Lower the waste container up to the
end-position.
Turn off the appliance
 Press brake pedal and keep it de-
pressed.
 Lock parking brake.
 Turn ignition key to "0" and remove it.
Close the gas inlet
 Close gas drawing valve by turning it in
clock-wise direction.
Transport
DANGER
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Turn ignition key to "0" and remove it.
 Lock parking brake.
 Close the gas inlet.
 Secure the appliance at the lashing
points (4x) using tension belts, ropes or
chains.
 Secure the wheels of the machine with
wheel chocks.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
8
-
EN
Storage/decommissioning
DANGER
Risk of injury and damage! Note the weight
of the appliance in case of storage.
 Park the sweeper on a level surface in
a dry, frost protected area. Protect it
against dust by means of covering ma-
terial.
 Raise the roller brush and the side-
brushes to prevent the bristles from be-
ing damaged.
 Turn ignition key to "0" and remove it.
 Lock parking brake.
 Close the gas inlet.
 Lock the sweeper to ensure that it does
not roll off.
 Gas engine
Caution
Machines must always be parked safe-
ly.
The machine - particularly the liquid gas
container and its connections - must be
inspected by a qualified person at regu-
lar intervals, as required by the regional
or national guidelines for safe opera-
tion.
Additionally observe the following points if
the sweeper is not used over a longer peri-
od of time:
 Change engine oil.
 Unscrew the gas hose with union nut
(use 30 mm spanner).
 Lock the gas bottle with the safety cap
and store upright in a suitable storage
area (also see Chapter "Safety instruc-
tions).
 Clean the inside and outside of the
sweeper.
 Disconnect the negative terminal of the
battery if the appliances is not used for
more than 4 weeks.
Illustration is symbolic
 Charge battery approx. every 2 months.
 Cover the battery and protect it from
short circuit.