Adding tracks to a programme
1
Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
DISC
TRACK
PLAY
MODE
ENTER
"P 1" shows Programme 1 is selected.
If you have labelled the disc, the bank edit
mode appears. Press (4) (PLAY MODE) to
display "P 1" above.
To select Programme 2, press (5) (n )
repeatedly until "P 2" appears.
2
Press (2) (N ) or (5) (n ) to select the
track slot number where you want to
insert a track.
Track slot number
DISC
TRACK
PLAY
MODE
ENTER
3
Push the SEEK/AMS control up or down
to select the track you want to insert.
4
Press (6) (ENTER) momentarily to enter
the track.
The current track in that slot number and
the succeeding tracks shift down.
To continue inserting tracks, repeat steps 2
through 4.
Note
Once all 12 slots have been filled,
"*Mem Full*" appears in the display, and you
cannot insert tracks.
5
When you finish inserting tracks, press
(4) (PLAY MODE) for two seconds.
6
Press (SHIFT).
Erasing tracks in a programme
1
Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
DISC
TRACK
PLAY
MODE
ENTER
"P 1" shows Programme 1 is selected.
If you have labelled the disc, the bank edit
mode appears. Press (4) (PLAY MODE) to
display "P 1" above.
To select Programme 2, press (5) (n )
repeatedly until "P 2" appears.
2
Press (2) (N ) or (5) (n ) to select the
track you want to erase.
Track slot number
DISC
TRACK
PLAY
MODE
ENTER
The track currently registered in slot 6 of
Programme 1.
3
Press (6) (ENTER) for two seconds.
When you erase a track from a slot number,
the succeeding tracks shift up to fill the gap.
DISC
TRACK
PLAY
MODE
ENTER
µ
DISC
TRACK
PLAY
MODE
ENTER
4
To continue erasing tracks, repeat steps
2 and 3.
5
When you finish erasing tracks, press (4)
(PLAY MODE) for two seconds.
6
Press (SHIFT).
EN
25