Fein Slugger JHM USA 101 X Instrucciones De Uso página 16

OBJ_BUCH-0000000057-007.book Page 16 Friday, August 31, 2018 12:06 PM
en
16
Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools, coolant container, handle,
chip guard, safety strap
Dove-tail guide (figure 12).
After several hours of operation, the play in
the dove-tail guide can increase. As a conse-
quence, the drill motor can glide along the
dove-tail guide by itself. This can lead to the
motor drifting down and damaging the cutting
tool. In this case, retighten all fastening screws
of the dove-tail guide correspondingly so that
the drilling motor can easily be moved manu-
ally, yet does not glide by itself.
Cooling-lubricant system.
Flush the cooling-lubricant system with
water, clean and drain it completely when not
using the machine for periods longer than
two weeks.
For continuous operation, the cooling-lubri-
cant system must be flushed with water and
cleaned approx. every 4 weeks.
Fig. 12
Dove-tail
guide
Mounting
screws