VALBERG WM 612 E W205T Instrucciones De Uso página 13

A
Using the appliance
5. At the end of the delay, all the delay lights go out and the selected programme starts.
NOTE:
You can pause the unit and add laundry during the delay period.
Changing the delay settings
If you want to change the delay time during its countdown time, you must cancel the
programme and set the delay time again.
Cancelling the delayed start function
If you want to cancel the delay and start the programme immediately:
1. Set the programme selector to any programme. This will cancel the Delay function. The
"Stop/Cancel» light will flash continuously.
2. Then select the programme you want to start again.
3. Press the "Start/Pause" button to start the programme.
Launching the programme
1. Press the "Start/Pause" button to start the programme.
2. A programme progress indicator corresponding to the start of the programme will light
up.
Child Lock
Use the child lock function to stop children from playing with the machine.
This prevents any unwanted changes from occurring while a programme is running.
NOTE:
- If you turn the programme selector when the child lock function is activated, the "Child
Lock on» indicator will flash 3 times. The Child Lock stops any changes being made to the
selected programmes or speed.
- Even if another programme is selected with the programme selector while the Child Lock
mode is active, the previously selected programme will continue to operate.
- When the child lock is active and the machine is running, you can pause the machine
without deactivating the child lock mode by turning the programme selector to the Off
position. When you then turn the programme selector, the programme will resume.
24 EN
A
Using the appliance
To activate the Child Lock:
Press and hold the Speed and Delay buttons simultaneously for 3 seconds.
While you hold the buttons for 3 seconds, the «Child Lock on» indicator will flash. Release
the buttons when the lights stay on permanently.
To deactivate the Child Lock:
Press and hold the Speed and Delay buttons simultaneously for 3 seconds once a programme
is activated. While you hold the buttons for 3 seconds, the «Child Lock on» indicator will
flash. Release the buttons when the light turns off.
NOTE:
- As well as the method above, to deactivate the Child Lock, move the program selector to
the Off position when no programme is running, and select another programme.
- The child lock mode is not deactivated after a power failure or when the washing machine
is unplugged.
Progress of the programme
The programme tracking indicator allows you to monitor the progress of the programme. At
the beginning of each new stage of the programme, the corresponding LED lights up and the
LED from the previous stage turns off.
You can change the speed settings without interrupting the programme progress once it
is activated. To do so, you must make the change for one stage after the one currently in
progress. If the change is not compatible, the relevant lights will flash 3 times.
NOTE:
If the machine does not go to the spinning stage, this may be because the Rinse
on hold function is activated or the automatic unbalanced load detection system is activated
due to the uneven distribution of laundry in the machine.
Locking the loading door
A locking system has been provided at the loading door of the machine to prevent the loading
door from opening when the water level is not correct.
The loading door indicator starts to flash when the machine is paused. The machine checks
the water level inside. If the water level is correct, the loading door indicator will turn off and
the loading door can only be opened after 1 to 2 minutes.
25 EN