VALBERG WM 612 E W205T Instrucciones De Uso página 20

B
Useful information
Problem
The water pressure is low.
The voltage could be low.
The water inlet temperature
Washing time is longer than
may be low.
stated in the manual.(*)
The number of rinses and/
or the amount of rinse
water may have increased.
Too much foam may have
formed and the automatic
foam absorption system
may have been activated
due to excessive use of
detergent.
38
Cause Solution
• The machine waits until it
senses an adequate amount
of water to avoid poor
washing quality due to low
water quantity. This is why
the washing time is longer.
• The washing time is
extended to avoid poor
washing results when the
supply voltage is low.
• The time needed to heat
the water is longer during
the cold seasons. The
washing time may also
be extended to avoid poor
washing results.
• The machine increases
the amount of rinse water
when a thorough rinse is
required and adds an extra
rinse stage if necessary.
• Use the recommended
amount of detergent.
EN
B
Useful information
Problem
The timer may be stopping
while water is being taken
in.
The duration of the
programme does not
change (on
models with a display) (*) The timer may be stopping
while water is being heated.
The timer may be stopping
during the spinning stage.
The programme duration is The machine may contain
not counted. (*) an unbalanced load.
The machine may contain
an unbalanced load.
The washing machine will
The machine does not move not spin if the water has not
to the spinning stage. (*) been completely drained.
Too much foam may have
formed and the automatic
foam absorption system
may have been activated
due to excessive use of
detergent.
39
Cause Solution
• The timer indicator does
not start until the machine
has taken in an adequate
amount of water. The
machine waits until there is
enough water to avoid poor
washing results. The timer
indicator will resume after
this operation.
• The timer indicator does
not start until the machine
has reached the selected
temperature.
• An automatic unbalanced
load detection system may
activate due to uneven
distribution of laundry
inside the drum.
• An automatic unbalanced
load detection system may
activate due to uneven
distribution of laundry
inside the drum.
• An automatic unbalanced
load detection system may
activate due to uneven
distribution of laundry
inside the drum.
• Check the filter and the
drain hose.
• Use the recommended
amount of detergent.
EN