Usage Purpose - STAMOS S-LS-1 Manual De Instrucciones

CAUTIONS
General safety information for the use of electrical devices:
To avoid injury from fire or electric shock, please ensure compliance with safety instructions when using this device. Please
read the instruction carefully and make sure that you have understood it well. Keep the manual near the equipment to
be able to read it at any time. Always use current sources connected to the ground and providing the necessary voltage
(indicated on the label on the device). If you have any doubt, let an electrician check that your outlet is properly grounded.
Never use a damaged power cable. Do not open the unit in damp or wet environment, or if you are wet yourself. Protect
the unit of solar radiation. Use the device in a protected location to avoid damaging the equipment or endangering others.
Make sure the device is able to cool and avoid placing it too close to other devices that produce heat. Before cleaning,
disconnect it. Use a soft damp cloth for cleaning. Avoid using detergent and make sure that no liquid enters the unit. No
internal element of this device needs to be maintained by the user. An opening of the device without our approval leads to
a loss of warranty.
General safety information for the use of the device:
• The user manual should be kept close to the device and should always be accessible for the users. Instruct your
employees how to use the device properly.
• Make sure the hot air can circulate well and place the device more than10 cm away from walls and other electrical
devices. Aerate well the working area.
• Do not place the device close to combustible materials.
• It may happen that by first use, the heating element produces a light smoke. This is absolutely normal. Simply check
that the smoke can evaporate and that a good aeration is provided.
• Clean the device regularly to avoid a durable encrustation of dirt.
TECHCNICAL DETAILS
Model
Voltage (V)
Rated current (A)
Power (W)
Temperature range (⁰C)
Output power (W)
Tip ground resistance
Tip ground voltage
Temperature range (⁰C)
Output power (W)
Air flow (L/min)
Output voltage DC (V)
Output current (A)
Voltage stability with load
Temperature coefficient
Ripple noise

USAGE PURPOSE

The device is designed for:
1. Different kind of soldering, de-soldering of the electronic components such as: SOIC, CHIP, QFP, PLCC, BGA, SMD, etc.
2. Shrinking, paint drying, adhesive removal, thawing, warming, plastic welding.
3. Power supply in scope of scientific research, product development, laboratories, etc.
EN
6100 S-LS-1
230 ~ 50Hz
6
1000
SOLDERING STATION
200 - 480
˂ 2ohm
75
˂ 2mV
SMD REWORK STATION
100 - 480
650
≤ 120
DC POWER SUPPLY
0 - 30
˂ 0.01% ±2mV
0 - 5
˂ 300ppm/°C
˂ 1mvrms
9