Regular Cleaning - STAMOS S-LS-1 Manual De Instrucciones

REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING IRON HEATING CORE ELE-
MENT
3
2
1
6
Before heater replacement make sure that the soldering iron is completely cold.
1. SOLDERING IRON TIP REPLACEMENT: remove the nut for mounting the soldering iron tip housing and take off
the housing. Replace the tip with the new one, place the housing and fix all with the plastic nut.
2. HEATER REPLACEMENT: remove the nut for mounting the soldering iron tip housing and take off the housing along
with the tip. Remove the nut for fixing the heater (4) and gently remove the heater (6) along with the board with
wires (7). Replace the whole remembering the wires connection order.

REGULAR CLEANING

Generalities
• Never clean the device with a pressurized water-jet, industrial cleaners, and brushes or any other type of cleaning
utensil that could damage the surface of the appliance.
• Before cleaning you must remove the electricity supply plug isolating the appliance from the main power circuit.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case, please contact your customer ser-
vice to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latest is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determinate the source of the problem if you make a detailed
and precise description of the matter. Avoid formulations like "the device doesn´t heat", which may mean that it
doesn´t heat enough or even not at all. Though, those two possibilities have a different causation!
The more detailed your information, the quicker the customer service will be able to answer your problem rapidly and
efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a loss of warran-
ty!
5
4
8
7
EN
1. nut for mounting the soldering iron tip housing
2. soldering iron tip housing
3. soldering iron tip
4. plastic nut for mounting the heater and the board
wires
5. spring
6. heater
7. wires board
8. handle
13