Regulatory Compliance and Safety Information—Cisco NCS 500 Series Routers
•
•
•
•
•
•
•
This document uses the following conventions:
Note
Means reader be careful. In this situation, you might perform an action that could result in equipment damage
or loss of data.
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in
the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Statements using this symbol are provided for additional information and to comply with regulatory and customer
requirements.
Statement 4—Power Supply Warning
Do not touch the power supply when the power cord is connected. For systems with a power switch, line voltages
Warning
are present within the power supply even when the power switch is off and the power cord is connected. For
systems without a power switch, line voltages are present within the power supply when the power cord is
connected.
All manuals and user guides at all-guides.com
Statement 7012—Equipment Interfacing with AC Power Ports, page 15
Statement 7013—Equipment Bonding Networks CBN, page 15
Statement 7016—Battery Return Conductor, page 15
Statement 7017—Minimum Steady State DC Input Voltage, page 16
Statement 8012—CE MARK with Name and Address of EU Authorized Representative, page 16
Statement 8015—Installation Location Network Telecommunications Facilities, page 16
Statement 8016—Installation Location Where the NEC Applies, page 16
Regulatory Compliance and Safety Information—Cisco NCS 500 Series Routers
3