Statement 12-Power Supply Disconnection Warning - Cisco ASR 920 Serie Manual Del Usuario

Regulatory Compliance and Safety Information-Cisco ASR 920 Series Aggregation Services Routers
•
•
•
•
•
•
•
•
This document uses the following conventions:
Means reader be careful. In this situation, you might perform an action that could result in equipment damage
Note
or loss of data.
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in
the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Statements using this symbol are provided for additional information and to comply with regulatory and customer
Warning
requirements.

Statement 12-Power Supply Disconnection Warning

Before working on a chassis or working near power supplies, unplug the power cord on AC units; disconnect the
Warning
power at the circuit breaker on DC units.
OL-32476-01 Rev. V4
Statement 7005-Intra-building Lightning Surge and AC Power Fault, page 14
Statement 7012-Equipment Interfacing with AC Power Ports, page 15
Statement 7013-Equipment Bonding Networks CBN, page 15
Statement 7016-Battery Return Conductor, page 15
Statement 7017-Minimum Steady State DC Input Voltage, page 15
Statement 8012-CE MARK with Name and Address of EU Authorized Representative, page 15
Statement 8015-Installation Location Network Telecommunications Facilities, page 16
Statement 8016-Installation Location where NEC applies, page 16
Regulatory Compliance and Safety Information-Cisco ASR 920 Series Aggregation Services Routers
3