Porter Cable PT10 Manual De Instrucciones página 4

• Air tools can become activated by accident
during main te nance or tool changes.
• Air tools can cause the workpiece to move
upon con tact lead ing to in ju ry.
• Loss of control of the tool can lead to injury
to self or others.
• Poor quality, improper, or damaged tools
such as grind ing wheels, chis els, sockets,
drills, nailers, staplers, etc., can fly apart
during operation, pro pel ling par ti cles
throughout the work area causing serious
injury.
• Fasteners could ricochet or be propelled
causing serious injury or prop er ty damage.
• Improperly maintained tools and accessories
can cause serious injury.
• There is a risk of bursting if the tool is
damaged.
• Use only accessories identified by the
manufacturer to be used with specific tools.
HAZARD
RISK OF ELETRIC SHOCK
WHAT COULD HAPPEN
• Using air tools to attach electrical wiring can
result in electrocution or death.
All manuals and user guides at all-guides.com
• Remove air hose to lubricate or add grind­
• Never carry the tool by the hose.
• Avoid unintentional starting. Don't carry
• Repair servicing should be done only by an
• Use clamps or other devices to prevent
• Never operate tool while under the
• Don't overreach. Keep proper footing and
• Keep handles dry, clean, and free from oil
• Stay alert. Watch what you are doing. Use
• Always use tool attachments rated for the
• Never use tools which have been dropped,
• Use only impact grade sockets on an
• Do not apply excessive force to the tool,
• Never point discharge of tool at self or
• Do not pull trigger unless tool contact
• Never attempt to drive fasteners into hard
• Take care to avoid driving a fastener on
• Position tool carefully so that fasteners will
• Maintain the tool with care.
• Keep a cutting tool sharp and clean.
• Check for misalignment or binding of
• Use of an accessory not intended for use
• Never use nailer/staplers to attach
4- ENG
ing attachments, sanding discs, drills, etc.
to the tool.
hooked-up tool with finger on trigger.
au tho rized ser vice rep re sen ta tive.
move ment.
influence of drugs or alcohol.
balance at all times.
and grease.
com mon sense. Do not operate tool when
you are tired.
speed of the power tool.
im pact ed or damaged by use.
impact wrench.
let the tool per form the work.
others.
safety device is against work surface.
surfaces such as steel, concrete, or tile.
top of another fastener.
be de liv ered to the proper location.
A properly maintained tool, with sharp
cutting edges reduces the risk of binding
and is easier to control.
moving parts, breakage of parts, and
any other condition that affects the tool's
operation. If damaged, have the tool
serviced before using.
with the specific tools, increases the risk of
injury to persons.
HOW TO PREVENT IT
electrical wiring while energized.