Network Setting - Sony VPL-VW100 Manual De Instrucciones

High Altitude Mode

Network Setting

You can set internet protocols such as IP address, Subnet Mask, Default
Gateway, and DNS Server when accessing the projector from a computer or
using "ImageDirector2" application supplied.
After completing all of settings, select "Apply" using m button, then press
ENTER.
IP Address Setup
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondry DNS
MAC Address
Note
To use the Network setting function,
Function
52
GB
Installation Menu
Use this item when using the projector at high altitudes.
Off: Use this setting when using the projector at normal altitudes.
On: Use this setting when using the projector at an altitude of 1,500
m or higher.
Note
When this item is set to "On," the number of turns of the fan
increases.
Selects either "Auto (DHCP)" or "Manual."
When you select "Manual," set the following "IP Address,"
"Subnet Mask," and "Default Gateway."
Sets the IP Address of the projector.
(1.0.0.0 to 223.255.255.255)
Sets the Subnet Mask of the projector.
(1.0.0.0 to 255.255.255.255)
Sets the Default Gateway of the projector.
(1.0.0.0 to 223.255.255.255)
Sets the DNS server to be used as a priority.
(1.0.0.0 to 223.255.255.255)
Sets the alternative DNS server.
(1.0.0.0 to 223.255.255.255)
Displays MAC address of the projector. You cannot change.
(1 page 50)
menu.
set "Standby Mode" to "Standard" in the