Others; Troubleshooting - Sony VPL-VW100 Manual De Instrucciones

Others

This section describes how to solve the problems, how to replace a lamp and
air filter, etc.

Troubleshooting

If the projector appears to be operating erratically, try to diagnose and correct
the problem using the following instructions. If the problem persists, consult
with qualified Sony personnel.
Power
Symptom
The power is not turned on.
Picture
Symptom
No picture.
The picture from the
IINPUT A connector is
colored strange.
The picture from the DVI-
D connector is colored
strange.
The picture from the
VIDEO INPUT or
S VIDEO INPUT
connector is colored
strange.
The picture is too dark.
Cause and Remedy
c Close the top cover and the lamp cover securely. (1 page 63)
c Reset the lamp release lever to its original position. (1 page 65)
c Close the filter holder securely. (1 page 67)
c Check warning indicators. (1 page 60)
Cause and Remedy
c Check that the proper connections have been made. (1 page
18)
c Select the input source correctly using the INPUT button. (1
page 30)
c Set the computer signal to output from an external monitor.
c Set the computer signal to output only to an external monitor.
c Select "Computer," "Component" or "Video GBR" for "Input-A
Signal Sel." and "DVI Signal Sel." on the Setup
according to the input signal. (1 page 53)
c Select "Computer," "Component" or "Video GBR" for "Input-A
Signal Sel." on the Setup
signal. (1 page 53)
c Select "Computer," or "Video GBR" for "DVI Signal Sel." in
the Setup menu according to the input signal. (1 page 53)
c Adjust the picture in the "Adjust Picture" of the Picture
menu (1 page 44)
c Set "Color System" in the Setup
system being input. (1 page 54)
c Adjust the contrast or brightness in the "Adjust Picture" of the
Picture menu properly. (1 page 44)
menu
menu according to the input
menu to match the color
Troubleshooting
59
GB