Others; Troubleshooting - Sony VPL-HS3 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Others

This section describes how to solve the
problems, how to replace a lamp and air
filter, etc.

Troubleshooting

Power
The power is not
turned on.
34
Troubleshooting
GB
c Wait for about one minute
before turning on the power.
(1 page 24)
c Close the lamp cover securely.
(1 page 36)
c Close the air filter cover
securely. (1 page 38)
Picture
c Check that the proper
No picture.
connections have been made.
(1 page 9)
c Select the input source correctly
using the INPUT button.
(1 page 23)
c Set the computer signal to output
from an external monitor.
c Set the computer signal to output
only to an external monitor.
c Select "Computer",
"Component" or "Video GBR"
for "Input-A Signal Sel" in the
SET SETTING
according to the input signal.
(1 page 31)
c Select "Computer",
The picture from the PJ
MULTI connector is
"Component" or "Video GBR"
colored strange.
for "Input-A Signal Sel" in the
SET SETTING
according to the input signal.
(1 page 31)
c Adjust the picture in the "Adjust
Color balance is
incorrect.
Picture ..." of the PICTURE
SETTING
(1 page 29).
c Set "Color System" in the SET
SETTING
the color system being input.
(1 page 31)
The picture is too dark. c Adjust the contrast or brightness
in the "Adjust Picture ..." of the
PICTURE SETTING
properly. (1 page 29)
The picture is not clear. c Adjust the focus with the
FOCUS ring. (1 page 23)
c Condensation has occurred on
the lens. Leave the projector for
about two hours with the power
on.
The picture flickers.
c Adjust "Dot Phase" for "Adjust
Signal..." in the INPUT
SETTING
(1 page 30)
menu
menu
menu
menu to match
menu
menu properly.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido