Putting Into Use - Wolf Garten POWER 34 Instrucciones De Funcionamiento Originales

Putting into use

Push the threaded pins Af into the quick-release
Î
levers Aa , until the hole is visible E 1 . Hold
these tightly with inger and thumb and screw
in the quick-release levers together with the
threaded pins in a clockwise direction G 2 until
there is a gap of approximately 10mm G 3 .
Secure the top part of the handle, by folding the
Î
quick release levers upwards G 4 .
Note
Depending on your height, you can select an
operating position for comfortable mowing
U I/II/III by releasing the two bottom quick
release levers U 1 and changing the
inclination of the assembled handle until the
desired height is obtained U 2 . Once the
handle is set to the desired height, snap the
bottom quick release levers back up again
U 3 .
Secure the cable to the lawnmower using the
Î
cable clips Ac (Fig. H ) at the bottom part Ah
and at the top part Ag of the handle.
Note
To simplify transport and storage, you can
fold the handle together. See "Transport and
storage" for more detailed information.
Assembling the grass collector (Fig. I J K )
Grip the frame with one hand on the handle I 1
Î
and use the other hand to pull the fabric collection
bag over the long end of the frame I 2 . Guide
the fabric collection bag through with its proile
section under the handle and attach the proile
section of the bag to the frame under the handle
I 3 .
Then fasten the side proile sections of the bag on
Î
to the frame, see J 1 - 3 .
Î Then turn the grass collector upside down and
attach the proile sections, see K 1 - 2 .
Putting into use
Supplementary documentation
Make sure the operating instructions of
the POWER Base 72V charger and of the
Li-High Energy 72V power pack are
available. Please read and understand
them before putting the lawnmower into
use.
72V Li-ION POWER 34-37-40
Safety function (Fig. P Z )
Note
The lawnmower is provided with a safety
circuit to prevent unauthorised use.
Risk of injuries or material damage.
¾ Insert the safety key P 1 immediately
prior to use.
¾ Always remove the safety key when
work with the lawnmower is interrupted
or inished.
2-position engagement device (Fig. O )
2 positions are available to prepare the power pack
for use or for storage and transport.
Position 1 O 3
3 The power pack is prepared for storage and
transport.
• Electric contacts are open to prevent the power
pack from self-discharging during storage.
Position 2 O 4
3 The power pack is prepared for use.
• Electric contacts are closed and the lawnmower
is ready for work.
Power pack charging
Risk of injuries or material damage.
¾ Only charge the power pack with charger
POWER Base 72V.
Attention !
The power pack is supplied partially charged.
Before irst use, fully charge the power pack using
the charger POWER Base 72V to ensure the full
capacity of the power pack.
Î Power pack charging must be carried out ac-
cording to the instructions in the supplementary
documentation.
WARNING !
WARNING !
EN
25