Honda CBX250 TWISTER Manual Del Propietário página 132

Owner´s Manual
(3)
Do not depress the brake lever when the wheel is off
the motorcycle. The caliper piston will be forced out of
the cylinders with subsequent loss of brake fluid. If
this occurs, servicing of the brake system will be
necessary. See your Honda dealer for this service.
(4)
Installation notes
Install the side collar into the right side wheel hub.
1. Position the front wheel between the fork legs and
insert the front axle shaft from the left side, through
the wheel hub and left fork leg.
(3) Axle pinch bolt
(5) Front axle shaft
(5)
(4) Front axle nut
To avoid damaging the brake pads while installing
the wheel, carefully fit the brake disc between the
pads.
2. Make sure that the lug (6) on the left fork leg is
contacting the lug (7) on the speedometer gear box.
3. Tighten the front axle shaft to the specified torque.
Front axle shaft torque:
59 N·m (6.0 kgf·m, 44 lbf·ft)
4. Tighten the axle pinch bolt on the left fork leg to the
specified torque.
Axle pinch bolt torque:
22 N·m (2.2 kgf·m, 16 lbf·ft)
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
5. Install the speedometer cable and tighten the screw
securely.
(7)
(6)
59
(6) Lug
(7) Lug