Idle Speed; Drive Chain - Honda CBX250 TWISTER Manual Del Propietário

Owner´s Manual

Idle Speed

(Refer to the Safety Precautions on page 43.
The engine must be at normal operating temperature
for accurate idle speed adjustment. Ten minutes of
stop-and-go riding is sufficient.
Do not attempt to compensate for faults in other
systems by adjusting idle speed. See your Honda
dealer for regularly scheduled carburetor adjustments.
1. Warm up the engine, shift to neutral, and place the
motorcycle on its side stand.
2. Adjust idle speed with the throttle stop screw (1).
Idle speed (In neutral):
–1
1,400 ± 100 min
(B)
(A)
(1)
)
(rpm)
(1) Throttle stop screw
(A) Increase rpm
(B) Decrease rpm

Drive Chain

(Refer to the Safety Precautions on page 43.
The service life of the drive chain is dependent upon
proper lubrication and adjustment. Poor maintenance
can cause premature wear or damage to the drive
chain and sprockets.
The drive chain should be checked and lubricated as
part of the Pre-ride Inspection (page 36). Under severe
usage, or when the motorcycle is ridden in unusually
dusty or muddy areas, more frequent maintenance will
be necessary.
Inspection
1. Turn the engine off, place the motorcycle on its side
stand, and shift the transmission into neutral.
2. Check slack in the lower drive chain run midway
between the sprockets.
Drive chain slack should be adjusted to allow the
following vertical movement by hand:
15 – 20 mm (0.6 – 0.8 in)
(1)
53
)
(1) Drive chain