Removing The Cover; Assembly - Fronius Acctiva Seller Manual De Instrucciones

Removing the
cover
Removing display and covers

Assembly

If installing the charger on a firm base, use drilling template enclosed in the packaging.
Remove the edge guard temporarily.
The space requirement measurements in mm (inches) illustrated below are given to
ensure that there is easy access to the plug connections:
Space requirements with edge guard
All manuals and user guides at all-guides.com
(1)
NOTE! IP44 is only guaranteed for the upright position.
If the charger is installed in a switch cabinet (or a similar sealed area), then
forced-air ventilation must be provided to ensure adequate heat dissipation.
There must be a clearance of 10 cm (3.94 in.) all around the charger.
168
(6.61)
If necessary, use a screwdriver to remove:
(2)
- Display (1)
- P4 connection cover (2)
multiport
270 (10.63)
*Space for fitting/removal
6
100 (3.94)
15,5 (.61)