Setting the advance speed (BD
model only)
Turn the running gear to the front with
your foot.
Reducing the speed: Turn the wheel in
– direction.
Increasing the speed: Turn the wheel in
+ direction.
Establish mains contact
Insert the looped end of the extension
cable in the strain relief hook.
Plug in the mains plug.
Cleaning
Turn the running gear to the back with
your foot.
Turn the program selection switch to
the desired cleaning program.
Set the water quantity according to the
degree of dirt accumulation and the
floor covering.
Lower the vacuum bar.
Turn on the brushes by pulling the con-
trol handle.
Caution
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Shutting Down the Appliance
Close the water quantity regulator.
Drive the appliance forward for another
1-2 m to draw off residual water.
Turn the program selection switch to
"OFF".
Raise the vacuum bar.
Turn the running gear to the front with
your foot.
Caution
Danger of deformation of the brush(es).
When shutting down the appliance relieve
the brush(es) by turning forward the run-
ning gear.
Emptying the Dirt Water Reservoir
Note
If the dirt water reservoir is full the float
closes the suction channel. The suction op-
eration is interrupted. Empty the dirt water
reservoir.
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Take the dirt water discharge hose from
the support and lower above a suited
collection device.
Let off water by opening the dosage de-
vice at the discharge hose.
The rinse the dirt water reservoir with
clear water.
EN
– 6
19