Before Startup - Kärcher K 5.75 Jubilee Manual Del Usuario

Operation
Scope of delivery
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
Description of the Appliance
Illustrations on fold-out page!
1 Transport handle
2 Storage for spray lance
3 Mains cable with mains plug
4 Wheels
5 Connection for water supply with filter
6 Coupling element for water connection
7 High pressure hose
8 High pressure connection
9 Appliance switch "0/OFF"/ „I/ON"
10 Storage for high-pressure hose
11 Detergent Tank
12 Suction hose for detergent
13 Storage for trigger gun
14 Lock trigger gun
15 Trigger gun
16 Key to detach the high-pressure hose
from the trigger gun
17 Spray lance with pressure regulation
(Vario Power)
18 Spray lance with Dirtblaster
19 Delta-Racer D150
Special accessories
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.

Before Startup

Illustration
Mount loose parts delivered with appliance
prior to start-up.
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
16
All manuals and user guides at all-guides.com
 Check the secure connection by pulling
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
 Screw the coupling element (supplied)
 Push the water supply hose onto the
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g.
from water butts or ponds (see specifica-
tions for max. suction height).
4
-
EN
Note: Make sure the connection nipple
is aligned correctly.
on the high-pressure hose.
Water supply
Warning
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
to the water connection on the appli-
ance.
coupling unit, then connect it to the wa-
ter supply.