Hach HQ1110 Manual Básico Del Usuario página 12

Figure 7 USB port plug installation
Section 6 Startup
6.1 Start the meter
Push to start the meter. If the meter does not start, make sure that the battery is installed
correctly or the meter is connected to a power source. Refer to Charge the battery on page 9.
6.2 Select the language
When the meter is powered on for the first time or when a new battery is installed, the display shows
the language selection screen. Select the applicable language. The user can also change the
language from the Settings menu.
6.3 Set the date and time
When the meter is powered on for the first time or when a new battery is installed, the display shows
the Date-Time screen. Complete the steps that follow to set the date and time.
Note: The user can also change the date and time from the Settings menu.
1. Push the up and down arrow keys to select a date format.
2. Push the right arrow to go to the date and time.
3. Push the up and down arrow keys to change the date and time.
4. Push the right arrow to highlight Save.
5. Select Save to keep the settings.
12 English