Specifications - Rotel RSP-1580 Manual De Instrucciones

44

Specifications

Audio
Total Harmonic Distortion
<0 .008%
Intermodulation Distortion (60Hz:7kHz)
<0 .008%
Frequency Response
10Hz - 120kHz, ±3dB (analog bypass)
10Hz - 95kHz, ±0.3dB (digital input)
Signal to Noise Ratio (IHF A-weighted)
95dB (analog bypass)
92dB (Dolby Digital, DTS) 0 dBFs
Input Sensitivity/Impedance
Line Level: 200 mV/100k ohms
Preamp Output Level/Output Impedance
1 .0V/1k ohms
Decodable Digital Input Signals
Dolby Digital, Dolby Digital EX, DTS, DTS-ES, DTS 96/24, DTS-ES 96/24, LPCM (up
to 192k) . Lossless audio formats (using HDMI 1 .3): Dolby TrueHD and DTS HD
Master Audio .
Decodable USB/iPod Digital Input Signals
AAC(m4a), WAV, MP3, WMA
Video
Input Resolutions
480i/576i, 480p/576p, 720p, 1080i
1080p, 1080p 24Hz, 3D (HDMI only)
Output Resolution
480i/576i (Composite, S-Video only), 480p/576p, 720p, 1080i
1080p, 1080p 24Hz, 3D (HDMI only)
Signal to Noise Ratio
45dB
Input Impedance
75 ohms
Ouput Impedance
75 ohms
Output Level
1 .0 volt
HMDI Inputs/Outputs
Version 1 .3, supporting Deep Color passthrough and Broad Color Space passthrough .
Version 1 .4, supporting 3D passthrough
RSP-1580 SURROUND SOUND PROCESSOR
General
Power Consumption
100 watts
0 .5 watt (standby)
Power Requirements (AC)
120 volts, 60Hz (USA version)
230 volts, 50Hz (EC version)
Weight
14kgs/31lbs
Dimension (W x H x D)
431 x 188 .2 x 405 mm
17 x 7 x 16 in
3/8
Front Panel Height (feet removed/for rack mount)
4U/177mm/7 in
When sizing openings in custom cabinets, measure the unit to be installed and/
or allow at least 1mm clearance on all sides for unit to unit tolerances. All
specifications are accurate at the time of printing. Rotel reserves the right to
make improvements without notice
Rotel and the Rotel Hifi logo are registered trademarks of The Rotel Co., Ltd.
Tokyo, Japan.
"
Made for iPod," and "Made for iPhone," means that an electronic
accessory has been designed to connect specifically to iPod or iPhone,
respectively, and has been certified by the developer to meet Apple
performance standards. Apple is not responsible for the operation of this
device or its compliance with safety and regulatory standards. Please
note that the use of this accessory with iPod, or iPhone may affect wireless
performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of
Apple Inc., registered in the U.S. and other countries.