Feature Identification - Tripp-Lite PowerVerter PV2000FC Manual Del Propietário

Feature Identification

1
ON-OFF-REMOTE Switch:
• Move the switch to the ON position to have your
Inverter provide connected equipment with AC power
by converting DC power from an attached battery.
• Leave the switch in the OFF position when not using
connected equipment to prevent battery drain.
• Set the 3-position switch to REMOTE to control
your Inverter at a distance with a wired remote
control module (Tripp Lite Model # APSRM4; sold
separately).
2
"LOAD" LEDs: intuitive "traffic light" signals show
the approximate connected equipment load level.
See Operation section for instructions on reading the
indicator lights.
3
"BATTERY" LEDs: these three lights will turn ON in
several sequences to show approximate battery charge
level. See Operation section for instructions on reading
the indicator lights.
4
DC Power Terminals: connect to your battery
terminals. See Battery Connection section for
instructions.
5
Resettable Circuit Breaker: protects your Inverter
against damage due to output overload. If the breaker
trips, remove some of the load on the Inverter to
prevent overload, then wait at least 1 minute to allow
components to cool before resetting the circuit breaker.
PV2000FC Front Panel
10
4
3 7 2 8 1
LOAD
BATTERY REMOTE LOAD
ON OFF REMOTE SENSE
HIGH LOW
MED MED MAX OFF
LOAD C/B 25 A
LOW HIGH 20A
4 6 5
6
NEMA 5-15/20R AC Receptacles: allow you to
connect equipment that would normally be plugged into
a utility outlet.
7
Remote Control Module Connector: allows remote
monitoring and control with an optional module
(Tripp Lite Model #APSRM4; sold separately). See
remote module owner's manual for connection
instructions.
8
Battery Charge Conserver (Load Sense) Dial:
conserves battery power by setting the low-load level
at which the Inverter automatically shuts off. See
Configuration section for setting instructions.
9
Main Ground Lug: properly grounds the Inverter to
vehicle grounding system or to earth ground. See
Configuration section for instructions.
10
Multi-Speed Cooling Fan: quiet, efficient fan prolongs
equipment service life.
11
Ignition Switch Control Jack (side panel, not
shown): use to connect the Inverter to your vehicle's
ignition switch (with user supplied cable) in order to
automatically control the Inverter with the vehicle's
ignition switch. See Operation section.
12
Inverter ON/OFF Indicator Jack (side panel, not
shown): use to connect the Inverter to a user-supplied
on/off indicator. See Operation section.
PV2000FC Rear Panel
11
12
4
9