Mounting (Optional) - Tripp-Lite PowerVerter PV2000FC Manual Del Propietário

Mounting (optional)

WARNING! Mount your Inverter BEFORE DC battery and AC power connection. Failure to follow these
instructions may lead to personal injury and/or damage to the Inverter and connected systems.
Tripp Lite manufactures a variety of different Inverters with a variety of different mounting options for use in vehicular or
non-vehicular applications. Tripp Lite recommends permanent mounting of your Inverter. User must supply mounting
hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of
the Inverter. Contact Tripp Lite if you require further assistance in mounting your Inverter.
1
Using the measurements from the diagram, install
two user-supplied ¼" (6 mm) fasteners into a rigid
horizontal surface, leaving the heads slightly raised.
2
Slide the Inverter forward over the fasteners to
engage the mounting feet molded on the front of the
Inverter cabinet. Install and tighten additional user-
supplied ¼" (6 mm) fasteners into the mounting feet
molded on the rear of the Inverter cabinet. The rear
feet extend beyond the unit's cabinet to provide for
adequate ventilation space behind the cooling fan(s);
they should not be removed.
The polycarbonate cabinet and mounting feet of
your Inverter are durable enough to allow for vertical
mounting as well, if your vehicle compartment
requires this configuration. For vertical mounting, the
con-trol panel of the Inverter should face up.
Allow 2" (5 cm.) minimum front and rear clearance for
adequate ventilation.
1
8
5.57 in.
(14.16 cm.)
2
15.02 in.
(38.12 cm.)
5.57 in.
(14.16 cm.)