Transport; Storage - AL-KO solo 130 MT Manual De Instrucciones

Transport

Malfunction
Engine starts, but the en-
gine output is low.
Engine not running
smoothly and engine
speed not increasing
when the throttle is ap-
plied.
Engine exhaust smoking
heavily, appears blue.
Engine starts abnormally
and vibrates strongly.
10 TRANSPORT
Transporting the appliance between two
working areas
1. Switch off the engine.
2. Put the transport protection onto the blade.
3. Hold the brushcutter firmly at the engine
block and the handle.
4. Walk carefully to the next working area. Take
care not to endanger persons or animals.
Transporting the appliance in a vehicle
1. If possible: Empty the fuel tank by allowing
the engine to run.
2. Switch off the engine.
3. Put the transport protection onto the blade.
4. Ensure that the appliance cannot tip over
while driving to prevent the petrol/oil mixture
from running out:
■
Place the appliance on the floor of the
vehicle so that the fuel tank cap is facing
443443_a
Cause
Choke lever is in CHOKE posi-
tion.
Air filter is clogged.
Fuel filter is worn.
Carburettor settings are not cor-
rect.
Spark plug is dirty, defective or
the electrode gap is not right.
Carburettor settings are not cor-
rect.
Amount of oil in the petrol/oil
mixture is too high.
Carburettor settings are not cor-
rect.
Appliance/engine parts have
come loose and/or are dam-
aged.
Remedy
Move choke lever to RUN.
see chapter 8.2 "Cleaning/replacing
the air filter (15)", page 34
Checking/replacing fuel filter (16)
Contact an authorised service work-
shop.
see chapter 8.4 "Servicing the spark
plug (16)", page 34
Contact an authorised service work-
shop.
Pour in petrol/oil mixture with correct
mixture ratio.
Mixing and pouring in the petrol/oil
mixture
Contact an authorised service work-
shop.
1. Stop the motor.
2. Inspect appliance for damage.
3. Check the spark plug, see chap-
ter 8.4 "Servicing the spark plug
(16)", page 34.
4. Contact an authorised service
workshop.
upwards. The fuel tank must be securely
closed.
■
Fix the appliance to the floor of the vehi-
cle.

11 STORAGE

If the appliance is not going to be used for more
than 2 – 3 months, the following work is neces-
sary to avoid any damage:
1. Empty the fuel tank:
■
Allow the engine to run until it stops itself.
Then there is no longer any petrol/oil mix-
ture in the fuel tank or carburettor and
deposits cannot form.
2. Clean the appliance:
■
Wipe the entire appliance and accessory
parts with a cleaning rag. Do not use pet-
rol or other solvents.
37