Troubleshooting Cloning Mode; Cloning Profile Id Number Through Wireless - Motorola DTR720 Manual De Instrucciones

English
7.5.3

Troubleshooting Cloning Mode

In the event that cloning fails, perform each of the following
steps before attempting to start cloning process again.
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-
Unit Chargers (SUC).
3 Ensure that there is no debris in the charging tray
or on the radio contacts and the radio contact is
touching the SUC or MUC contact firmly.
4 Ensure that the Target Radio is turned on.
5 Ensure that the Source Radio is in cloning mode.
6 Ensure that the two radios are both from the same
frequency band, and same region.
50
NOTE:
This cloning cable is designed to operate only
with compatible Motorola Solutions SUC.
When ordering cloning cable kit, refer to part number
HKKN4028_ For more information about the accessories,
see Accessories on page 75
7.5.4
Cloning PROFILE ID Number Through
Wireless
The PROFILE ID Number Wireless Cloning feature is
useful when you want to clone the PROFILE ID Number
for all the radios in your fleet but you do not want
to clone particular radio settings that may be unique
for each radio (like Programmable button configuration,
Microphone Gain, Radio Name and others). It is also useful
if you do not have a programming cable, or PC available
to use with the Customer Programming Software (CPS)
configuration.
The Profile ID feature is enabled through CPS
configuration.
1 Power the Target Radio and perform the following
actions: