EBARA E-SPD+ Manual De Instrucciones Y Mantenimento página 34

Par. Description
DRY RUNNING TRIGGER
5.55
LEVEL
DRY RUNNING ALARM
5.56
DELAY
5.57 BURST PIPE ALARM
5.58 VOLTAGE ALARM ACTIVE
5.59 MOTOR THERMISTOR TYPE
MOTOR THERMISTOR
5.60
TRIGGER LEVELL
PARAMETER LOCK
5.61
SET DATE AND TIME
5.62
STOP FREQUENCY SEARCH
5.63
WIZARD
5.64 FACTORY DEFAULT RESET
(1) In B mode, is only available with 2 transducers
(2) In E mode, is only available with 2 transducers
Programming
Units
Default Min.
% 25 10
Sec 5 1
YES YES
YES YES
OFF
kohm 1 0,5
NO NO
NO NO
NO NO
NO NO
Max.
Allows you to fine-tune the sensitivity of the protection
90
triggering by detection of dry running.
Time from when the system calculates a low water level
99
until the moment the alarm is activated for this reason.
Parameter for enabling or disabling the detection of the
NO
broke pipe.
Parameter for enabling or disabling the alarm due to
NO
a power cut.
OFF
By this parameter, select the type of motor thermistor
PTC
available for motor protection.
NTC
By this parameter, set the trigger level of motor
99,9
thermistor connected.
YES: Editing the values of the parameters is locked.
NO: Editing the values of the parameters is unlocked.
To change this parameter from YES to NO, you must
YES
enter the password 1357 or another password generated
previously by the user.
When you change this parameters to "YES" this screen
YES for editing the date and time will appear. Once editing is
completed, the parameter returns to "NO".
If you change this parameter from "NO" to "YES" the stop
YES
frequency search wizard will be launched.
To reset the unit and leave it with the factory settings,
change this parameter to "YES" and after you have
YES
entered the code 1357 the unit will launch the start-up
wizard.
34
Notes
A
X
X
X
X
X
X
X
X
X
EN
Application
B C D E
X X X X
X X X X
X X X X
X X X X
X X X X
X X X X
X X X X