Operation; Cleaning Methods; Normal Soiling; Upholstery Cleaning - Kärcher Puzzi 400 K Manual De Instrucciones

Warning
Health risk, risk of damage. Observe all in-
dications on the detergent used.
Note: Warm water (max. 50°C) will in-
crease the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
Illustration
 Fill the detergent tank with maximum 35
litres of the cleaning solution.

Operation

Note: There is an additional socket to con-
nect electrical accessory devices.
Turning on the Appliance
 Plug in the main plug.
 Press the suction switch to turn on the
suction turbine.
 Press the spray switch to turn on the de-
tergent pump.
 Set the desired pressure or water vol-
ume by means of the water volume reg-
ulating valve.
High pressure = large water volume
 Only with continuous operation:
Press the disposal pump switch to
switch on the disposal pump.
Cleaning
Caution
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
Illustration
 Use the lever on the bender to spray on
detergent solution.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Only with continuous operation:
–
Waste water is transported away via the
connected hose.
All manuals and user guides at all-guides.com
–
Only with discontinuous operation:
 If the dirt water reservoir is full, switch
 Remove the lid.
 Remove the wastewater container from
 Spray and suction off detergent solution
Note: Repeated suctioning without spray-
ing will shorten the drying time.
 Apply detergent solution with suction
 Clean the surface just like with normal
 In order to further improve the cleaning
 Attach hand nozzle instead of the floor
 With sensitive materials, use less deter-
– 3
EN
Only with discontinuous operation:
The suction flow is interrupted by the
swimmer when the wastewater tank is
full.
Empty the dirt water reservoir
off the suction and spray switches.
the appliance and empty it or drain it via
the drain hose.

Cleaning methods

Normal soiling

in one work cycle.
Strong soiling or stains
turbine turned off and soak for 10 to 15
minutes.
soiling.
result, the surface can be recleaned us-
ing clear, warm water.
Only with continuous operation: Set
dosing valve for detergent to "0".

Upholstery cleaning

nozzle.
gent and spray the surface at a distance
of approx. 200 mm. Then simply vacu-
um off.
15