Bebeconfort Ever Fix Manual Del Usuario página 32

Baby in the Ever Fix car seat :
• Never leave your child unattended.
• For your own safety and the one of your child always put
the child in the car seat and fasten him however short your
journey may be.
• Use the Bébé Confort Ever Fix only on a front-facing seat
that is fitted with an automatic or static 3-point belt that
has been approved according to the ECE R16 standard or
similar. Do NOT use a 2-point belt.
• After putting the child in the car seat, ensure that the
harness is sufficiently tight by pulling the belt. Before every
use, make sure the harness is not damaged or twisted.
• Make sure you can fit no more than one finger between
the harnesses and your child (1cm). If there is more space
than 1 cm, tighten the harness belt further.
• Check to make sure the headrest is adjusted to the proper
height.
• Ensure that the straps under the stomach lie as low as
possible, to properly support the pelvis.
• Do not use the child restraint device without the cover.
Do not replace the seat cover with any other than the one
recommended by the manufacturer, because it will have a
direct effect on the functioning of the car seat.
• The temperature inside a vehicle may become very high,
particularly after a long period of exposure to the sun. It is
strongly recommended, under such conditions, to cover
the seat of the car with a piece of material or something
equivalent to prevent the harness fixings, and in particular
the metal parts, from becoming hot and burning the child.
WARNING
In ISOFIX use the fitting clips for lower anchorage to the
vehicle are not sufficient. It is essential to fix the "TOP TETHER"
to the upper anchorage point recommended by the car
manufacturer. Fitting the Ever Fix seat with additional tethers
using the vehicle' s ISOFIX additional anchorage points.
The ISOFIX anchors have been developed to obtain a safe
and easy fixation of the child safety systems inside the car. Not
all cars are equipped with these anchors although they are
EN
standard on more recent models. For a complete list of cars,
please visit our website www.bebeconfort.com.
• In forward facing position, the seat must be placed on the
car rear seat or exceptionally on the front seat in accor-
dance with the legislation in force in the country of use
(In France: in accordance with the conditions stipulated
in decree n° 91-1321 du 27-12-1991).If you use the Ever
Fix on the front seat, it is recommented to deactivate the
airbag of the seat in question and move the passenger
seat back to a maximum (Please consult your car manual).
• When installing the car seat, it is necessary to remove the
headrest in order to put the TOP TETHER through correctly.
• Warning: when installing the car seat, spaces between
the base of the car seat and the vehicle seat are possible
depending on the position of the anchorage points within
the vehicle.
• The rigid parts and the plastic sections of a child restraint
device should be positioned and installed in such a way
that they cannot, when the vehicle is being used under
normal conditions, become trapped under a moving seat
or in the vehicle door.
• Never modify the construction or the materials of the car
seat and the seat belt without consulting the manufactu-
rer.
• This child restraint is effective only if the instructions for use
are respected.
• Always fasten the child restraint even when the child is not
sitting in it.
• Never place heavy objects on the rear parcel shelf, to avoid
the danger of projectiles in the event of an accident.
• Always check that no part of the seat or the harness is
trapped under a seat or in the vehicle door.
• If in any doubt about the correct installation or use of the
system, the user is advised to contact the distributor or the
manufacturer of the child restraining device system.
32