Blade Replacement - Cembre TC065-SC Manual De Uso Y Mantenimiento

Cabeza hidraulica de corte
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3.4) Storage
(Ref. to Fig. 3)
When not in use, the head should be stored and transported in its metal case, to prevent damage.
Metal case: "VAL TC065-SC" size: 459x231x122 mm (18x9x4.8 in.), weight: 14,6 kg (10.1 lbs).

3.5) Blade replacement

After extended use, the blades may lose their cutting edge.
Replace the blades as follows:
Connect the cutting head to the hydraulic pump.
Operate the pump so to advance the ram until the pins (12) of the blades are visible (Fig. 5a) and
than disconnect the pump.
Remove circlips (13) and extract the pins (12); to ease the operation it may be necessary to fold
back the rubber hand grip (2).
Remove the nut (15), 2 spacers (17), 2 pins (18) so to extract the central pin (19) and free the blades.
Disassemble the blade guide (5) keeping aside the screw (14).
Assemble the new blades (1) the pivot (19) and pins (18).
Lock the pin (19) with the nut (15) washer (16) and spacer.
Assemble the 2 pins (12) and lock them with circlips (13).
Assemble the blade guide (5).
At the end of the operation, connect the head to the pump and press the oil release control
of the pump to withdraw the ram of the head.
(Ref. to Fig. 5)
6

Publicidad

Tabla de contenido
loading

Tabla de contenido