Taring The Balance; Performing A Weighing; Transporting, Packing, And Storing; Transporting Over Short Distances - Mettler Toledo XK-KC Manual De Usuario

4.6.2 Taring the balance

If a weighing container is used, the balance must be tared.
1 Clear the weighing pan.
2 Press [ ] to zero the balance.
3 Place the container on the weighing pan.
4 Press [
The balance is tared. The icon Net appears.

4.6.3 Performing a weighing

The weighing pan is clear and the display shows 0.
1 Load a weight onto the weighing pan.
The display shows the corresponding weight.
2 Remove the weight from the weighing pan.
The display shows 0.

4.7 Transporting, packing, and storing

Injury due to lifting heavy objects
Attempts to lift the instrument by a single person could cause injuries.
Do not move or lift this equipment without assistance.
Preparing the balance for transport
The balance is switched on.
1 Unplug the power cable from the power outlet.
The balance is switched off.
2 Disconnect the connection cable from the terminal and the weighing platform.
The balance is ready for transport.

4.7.1 Transporting over short distances

To move the balance over a short distance to a new location, follow the instructions below.
The balance is prepared for transport.
1 Remove the weighing pan to transport it separately to the new location.
2 Carefully lift the weighing platform and carry it in horizontal position to the new location.
3 Carefully lift the terminal and carry it to the new location.
To put the balance into operation, proceed as follows:
1 Connect the cables in reverse order.
2 Level the balance.
3 Install the weighing pan.
4 Perform an adjustment.
See also
Leveling the balance Page 9
Adjusting the balance Page 10

4.7.2 Transporting over long distances

To transport the balance over long distances, always use the original packaging.
Comparator Balances
] to tare the balance.
WARNING
11