Pre Operation Checklist; Scheduled Maintenance Quick Reference - Husqvarna FS 4800 D Manual De Instrucciones

Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly
and your machine will give you long service in normal operating conditions.
Before starting up the machine, make sure you read these entire Operating Instructions and are
familiar with the operation of the machine.
MACHINE SET-UP:
ALWAYS park machine on a level surface with the engine "OFF" and the ignition switch set in the
"0" (OFF) position before performing any maintenance. Let the machine cool down!!
1. Check engine oil. Fill to the full mark on dip stick with 15W40 oil.
. Connect battery cables.
1 - 2 HOUR OPERATION CHECK LIST:
ALWAYS park machine on a level surface with the engine "OFF" and the ignition switch set in the
"0" (OFF) position before performing any maintenance. Let the machine cool down!!
1. Check the engine air cleaner hose clamps. Tighten as required.
. Tension the blade drive V-belts. DO NOT over tension!!

SCHEDULED MAINTENANCE QUICK REFERENCE

Before performing any maintenance, ALWAYS park the machine on a level surface with the engine
"OFF" and the ignition switch set in the "OFF" position. Let the machine cool down!!
SERVICE DAILY:
1. Check engine oil level.
. Check blade guard for damage.
. Check hoses and clamps for damage or looseness.
Tighten or replace as necessary.
4. Check air cleaner AIR RESTRICTION INDICATOR
5. Make sure all safety guards are in place and in
good condition.
6. Drain Water from ENGINE GEARBOX (-1A, -A)
using WATER DRAIN VALVE (-1C, -C).
SERVICE EVERY 50 HOURS:
1. Inspect Radiator Air Filter and clean as necessary.
. Check blade drive V-belt tension. Tension both sides
evenly. DO NOT over tension!!!
. Lubricate front wheel bearings.
4. Replace Hydraulic System Filter. (First 50
hours only.)
44

PRE OPERATION CHECKLIST

SERVICE EVERY 100 HOURS:
. Lubricate front axle pivot bearings.
. Check wheels for wear or damage.
4. Check rear wheel hubs and wheels for looseness.
5. Check engine air cleaner hose and clamps.
SERVICE EVERY 250 HOURS:
1. Replace Hydraulic System Filter
. Grease Blade Shaft  pumps each end.
SERVICE EVERY 500 HOURS:
SERVICE YEARLY: