VALBERG WF 814 B AID DG 701T Instrucciones De Uso página 6

B
Using the appliance
~ 95 cm
~ 145 cm
~ 95 cm
 Connect new water inlet hoses to a ¾ ˝, threaded tap.
• Connect the white capped end of the water inlet hose to the white water inlet valve on
the rear side of the machine and the red capped end of the hose to the red water inlet valve
(if applicable).
• Hand tighten the connections. If in any doubt, consult a qualified plumber.
• Water flow with pressure of 0. 1-1 Mpa will allow your machine to operate at optimum
efficiency (pressure of 0. 1 Mpa means that more than 8 litres of water per minute will flow
through a fully opened tap).
 Once you have made all of the connections, carefully turn the water supply on and check
for leaks.
 Ensure that the new water inlet hoses are not trapped, kinked, twisted, folded or crushed.
• If your machine has a hot water inlet connection, the temperature of the hot water supply
should not be higher than 70°C.
NOTE
Your Washing Machine must only be connected to your
water supply using the supplied new fill hose. Old hoses
must not be reused.
~ 140 cm
~ 95 cm
~ 150 cm
8 EN
B
Using the appliance
Water Discharge Connection
• Connect the water drain hose to a standpipe or to the outlet elbow of a household sink,
using additional equipment.
• Never attempt to extend the water drain hose.
• Do not put the water drain hose from your machine into a container, bucket or bathtub.
• Make sure that the water drain hose is not bent, buckled, crushed or extended.
• The water drain hose must be installed at a maximum height of 100 cm from the ground.
9 EN