Control Panel; Getting Started - Klarstein ICEWIND MAX Manual De Instrucciones

CONTROL PANEL

GETTING STARTED

1. Open the packaging and remove the device. Make sure that all items included
in the scope of delivery are complete.
2. Place the device horizontally on a stable surface. Do not tilt the unit before
use. Before starting the device, make sure that the voltage of the socket used
corresponds to the voltage specified on the type plate of the device.
Adding water
• First remove the water tank from the machine. Before removing the water
tank, make sure that all the residual water from the pump system has already
flowed back into the water tank to prevent the water from flowing out of the
appliance.
• Observe the minimum and maximum markings in the water tank.
Note: Make sure that the water level is always between the two marks and
never exceeds the maximum mark, otherwise the water could overflow. Before
filling with water, remove the cardboard attached to the left side of the water
tank.
Display
Display
EN
27