Klarstein ICEWIND MAX Manual De Instrucciones página 30

EN
30
Swing function
In operating mode, press this button to switch on the oscillation function. Each
time you press it once, the functions are called up in the following order: Swing Up
and Down > Swing Left and Right > Swing OFF > Swing Left and Right > Swing Up
and Down > Swing OFF.
Humidification
When this button is pressed in the operating mode of the unit, the humidification
function can be activated or deactivated. The corresponding indicator lamp lights
up.
Note: Check the water level in the water tank before activating the
humidification function. If the water level is below the minimum mark, the
water must be topped up.
Lower water level
If there is not enough water in the water tank, the unit automatically stops
operating in humidification mode. The humidification indicator or the "Low
water level" indicator flashes. Fill the water tank. Then restart the humidification
function.
Screen illumination
If no button is pressed within 40 seconds, the screen illumination is dimmed by
50 %. Press any button to make the screen fully lit again.
Memory function
This unit has a memory function. When the unit is put into standby mode, the
previously set function is saved. When you switch the unit on again, it will then
automatically start in the previously saved function.
Automatic standby mode
If no button is pressed within 15 hours, the unit is automatically set to standby
mode.