Mounting The Fascia Door; Important - Fulgor Milano FBR 300 F ED Manual De Usuario

EN

Mounting the fascia door

• Ensure that there is a gap of 3 to 4mm between the non-
hinged side and the cabinet wall.
• Locate the slider in the bracket and fix the slider to the fascia
door 20 to 22mm from the edge of the fascia as shown in
figure 11, ensuring that the slider is positioned centrally and
horizontally within the bracket. Tighten securely by hand.
• Fill the gap on the non-hinged side with the gasket/seal strip
provided, as shown in Fig. 12.
• The finished look for the door sliders should be similar to
those shown in Fig. 14, which shows 2 sliders in place.
• Ensure the appliance door opens, closes and seals properly.
Once complete, and if you are happy with the fit of the
appliance in the cabinet, bend and snap the parts of the white
spacers marked 'S' as shown by the dotted outline in fig. 13.
Leave the rest of the spacer cover in place over the metal plates.
Gasket
14
Fig. 11
Fig. 12
Fig. 13
Fig 14

IMPORTANT

After completing the installation, check that the
appliance is secured within the unit and that the
door(s) close and open properly. If there is no
resistance from the door seals when opening the
doors, then it is probable that the appliance and/
or decor doors are not fitted properly.
Decor door